Publicité
Certifications
* For detailed product information, please visit our website: http://www.asrock.com
WARNING
Please realize that there is a certain risk involved with overclocking, including adjusting
the setting in the BIOS, applying Untied Overclocking Technology, or using the third-
party overclocking tools. Overclocking may affect your system stability, or even
cause damage to the components and devices of your system. It should be done at
your own risk and expense. We are not responsible for possible damage caused by
overclocking.
CAUTION!
1.
About the setting of "Hyper Threading Technology", please check page 34
of "User Manual" in the support CD.
2.
This motherboard supports Untied Overclocking Technology. Please read
"Untied Overclocking Technology" on page 21 for details.
3.
This motherboard supports Dual Channel Memory Technology. Before you
implement Dual Channel Memory Technology, make sure to read the
installation guide of memory modules on page 14 for proper installation.
4.
Please check the table below for the CPU FSB frequency and its
corresponding memory support frequency.
CPU FSB Frequency
1333
1066
800
533
* DDR3 1333 memory modules will operate in overclocking mode.
* When you use a FSB533-CPU on this motherboard, it will run at
DDR3 533 if you adopt a DDR3 800 memory module.
* If you adopt FSB1333-CPU and DDR3 1333 memory module on this
motherboard, you need to adjust the jumper. Please refer to page 17 for
proper jumper settings.
5.
Due to the operating system limitation, the actual memory size may be
less than 4GB for the reservation for system usage under Windows
Vista
TM
/ XP. For Windows
6.
The maximum shared memory size is defined by the chipset vendor and
is subject to change. Please check Intel
7.
Before installing SATAII hard disk to SATAII connector, please read the "SATAII
Hard Disk Setup Guide" on page 24 of "User Manual" in the support CD to
adjust your SATAII hard disk drive to SATAII mode. You can also connect SATA
hard disk to SATAII connector directly.
8.
Power Management for USB 2.0 works fine under Microsoft
64-bit / 7 / Vista
8 8 8 8 8
ASRock G41M-VGS3 / G41M-VS3 Motherboard
- FCC, CE, WHQL
- ErP/EuP Ready (ErP/EuP ready power supply is required)
(see CAUTION 19)
Memory Support Frequency
DDR3 800, DDR3 1066, DDR3 1333
DDR3 800, DDR3 1066
DDR3 800
DDR3 800
®
OS with 64-bit CPU, there is no such limitation.
®
website for the latest information.
TM
64-bit / Vista
TM
/ XP 64-bit / XP SP1 or SP2.
®
7 /
®
Windows
®
7
Publicité
