Publicité
Les langues disponibles
Les langues disponibles
AUDIBLE SIGNALS
DURING OVEN SETTINGS
SETTING THE CLOCK
The CLOCK and the "0" button are combined to one
single button. The clock function is a 12-hour system.
To set the clock follow the steps below:
1) While in stand-by mode, press "0 / Clock"
button for approximately 3 seconds.
2) Using the number pads enter the correct time.
(The digital clock will allow a setting of 1:00 to
12:59). You must press at least 3 numbers (1
for hour and two for minutes)
3) Once the desired time is entered, press the
START / +30 Sec to confirm the setting and
exit the clock setting mode
NOTE:
When a setting is less than four numbers (0:00),
press START/+30 SEC to confirm the setting. You
don't need to press START/+30 SEC pad when a
setting is 4 numbers（00：00), cause the setting
of 4 numbers is confirmed and exited the clock
setting mode directly
You can check the clock time while cooking is in
progress by touching the CLOCK pad.
EXPRESS COOK
Use the EXPRESS COOK buttons (1 – 6) for quick
start pre-timed cooking.
Number
Cook Time
pad
1
1 Minute
2
2 Minutes
3
3 Minutes
4
4 Minutes
5
5 Minutes
6
6 Minutes
ADD 30 SECONDS
Touch this button for quick 30 second cook time.
Pressing this button during a set cook cycle will add
30 seconds to the current time.
Every time the button is pressed an additional 30
seconds will be added to the current cook time.
NOTE:
During the EXPRESS COOK, AND TIME
DEFROST, you can add 30 seconds each time the
button is pressed.
HOW TO SET THE OVEN CONTROLS
ONE SIGNAL: Oven accepts the entry.
TWO SIGNALS: Oven does not accept the entry, check and try
again.
SETTING A COOKING PROGRAM
SETTING THE KITCHEN TIMER
Touch TIMER.
1.
Enter the desired amount of time by touching
2.
the number pads. Time is in minutes and
seconds and set from left to right.
Display will show the desired setting:
3.
(00:05 for 5 seconds / 24:05 for 24 minutes and
5 seconds)
Touch Start / +30 Sec to start the countdown.
4.
Note: Time countdown can be seen in display for 5
seconds before clock or cooking time is returned to
display.
Touch timer button and then STOP / CANCEL to
cancel the timer during the countdown process.
A. One-stage Cooking
Touch the POWER pad to select
the power level, the settings will
cycle according to the table
shown.
1.
Use the number pads to set
a cooking time. You can set
a cooking time from one
second to 99 minutes and
99 seconds.
2.
Press the START/+30 Sec button to start the
cooking process
11
POWER
Cooking
pad
power
HIGH
100%
M. HIGH
80%
MED
50%
M. LOW
30%
LOW
10%
Publicité
