Makita XPK01 Manuel D'instructions page 7

1
7
002566
6. Set the drum cover over the adjusting plate/set
plate and screw in the three hex flange head bolts
so that a gap exists between the drum and the set
plate to slide the mini planer blade into position.
The blade will be positioned by the planer blade
locating lugs on the set plate.
7. The blade's lengthwise adjustment will need to be
manually positioned so that the blade ends are
clear and equidistant from the housing on one
side and the metal bracket on the other.
8. Tighten the three hex flange head bolts (with the
socket wrench provided) and hand rotate the
drum to check clearances between the blade
ends and the tool body.
9. Check the three hex flange head bolts for final
tightness.
10. Repeat procedures 1 - 9 for other blade.
Installing conventional planer blade
(optional accessory)
To install the blades, first clean out all chips or foreign
matter adhering to the drum or blades. Use blades of the
same dimensions
oscillation/vibration will result, causing poor planing
action and, eventually, tool breakdown.
2
3
4
5
002555
Place the blade on the gauge base so that the blade
edge is perfectly flush with the inside edge of the gauge
plate. Place the adjusting plate on the blade, then simply
press in the heel of the adjusting plate flush with the
back side of the gauge base and tighten two screws on
the adjusting plate. Now slip the heel of the adjusting
plate into the drum groove, then fit the drum cover on it.
Tighten all the installation bolts evenly and alternately
with the socket wrench.
Repeat the above procedures for the other blade.
1. Mini planer
6
blade
5
2. Groove
3. Set plate
4. Hex. flange
head bolts
4
5. Drum cover
3
6. Drum
2
7. Adjusting plate
and weight, or
1. Bolts
1
2. Drum
3. Planer blade
4. Drum cover
5. Adjusting plate
2
3
4
5
6
7
002556
drum
7
1. Inside edge of
gauge plate
2. Blade edge
3. Planer blade
4. Adjusting plate
1
5. Screws
6. Heel
7. Back side of
8
gauge base
8. Gauge plate
9
9. Gauge base