Home Decorators Collection 15614 Instructions D'assemblage page 3

Pre-Installation
PLANNING INSTALLATION
To ensure your installation goes smoothly, please read these instructions carefully and review the recommended tools and hardware before
you begin.
To remove the old vanity (if applicable): 1) Turn off the water supply and drain out. 2) Disconnect the supply lines from the faucet.
3) Remove the old vanity top and vanity. If the new vanity is not installed immediately, temporarily stuff a rag into the drain pipes.
TOOLS REQUIRED
Electric drill
with #2 drill bit
Safety
goggles
HARDWARE INCLUDED
NOTE: Hardware shown to actual size.
Part Description
AA Handle
BB 3/4 in. screw
Two #8 x 2 in.
screws
Phillips
screwdriver
BB
Quantity
2
4
3
Please contact 1-800-986-3460 for further assistance.
Two wall
anchors: if the
vanity will not
be screwed to
wall studs
Silicone
(optional)
__________AA
HOMEDEPOT.COM/HOMEDECORATORS
Level
Pliers