Suncast BMS6582 Instructions D'assemblage page 14

Header Pre-Assembly
Place Front Header (K) face down on flat surface. Place one header beam (Y) in each channel above and below the
window openings. Secure Beams (Y) with two screws (NN) each. Place short side adapter (CC) between windows
with the flat bottom end facing down. Secure adapter (CC) with four screws (NN).
Place Rear Header (L) face down on flat surface. Place remaining header beam (Y) in channel on back of header.
Secure Beam (Y) with two screws (NN). Place support bracket (Z) at center of beam with the flat bottom end facing
down. Secure bracket (Z) with two screws (NN).
14