Publicité
Les langues disponibles
Les langues disponibles
FIGURES
(P. 28-31)
CONNECTIONS AND CONTROLLERS (FIG. 1)
(1)
Power-/Protection-LED
(2)
HIGH PASS controller
(3)
Selector HP (Highpass) – FULL – LP/BP (Lowpass/Bandpass)
(4)
LOW PASS controller
(5)
LINE OUTPUT L/R
(6)
LINE INPUT L/R
(7)
BASS BOOST controller
(8)
LEVEL INPUT controller
POWER SUPPLY AND TURN ON CONNECTION (FIG. 2)
(1)
GND terminal for the ground
(2)
REM terminal for the turn on connection
(3)
+12 V terminal for the positive-connection of the battery
(4)
Vehicle's battery
(5)
In-Line Fuse (not included in the scope of delivery)
(6)
Turn on wire from the head unit or the electrical antenna
(7)
Fuse(s)
2-CHANNEL OPERATION STEREO (FIG. 3)
If you want to run the amplifier with the 2 line output channels from the head unit to drive two loudspeakers in
stereo, connect the following setup:
(1)
To the head unit, line output left FRONT L/CH1
(2)
To the head unit, line output right FRONT R/CH2
(3)
Loudspeaker left FRONT L/CH1
(4)
Loudspeaker right FRONT R/CH2
MONO OPERATION (FIG. 4)
If you want to run the amplifier with the 2 line output channels from the head unit to drive a subwoofer, connect
the following setup:
(1)
To the head unit, line output left FRONT L/CH1 or subwoofer output
(2)
To the head unit, line output right FRONT R/CH2 or subwoofer output
(3)
Subwoofer
11
Publicité
