Diamond CF1N/F64 Manuel D'installation page 38

5.3. Manual Heating Cycle
By selecting this area
menu is loaded.
From this screen it is possible to enter the manual
REFRIGERATION or HEATING cycles.
Before starting the desired cycle, by pressing
within the red coloured area for heating, it is
possible to access the setpoint editing functions.
To change the temperature and relative humidity
values, press the and
scroll bar icon. Press
values or press to quit the procedure and
return to the previous level without saving.
To start the manual cycle press
following screen will be displayed:
, the MANUAL
keys or drag the
to confirm the new set
. The
During the manual cycle, the control keys are
displayed at the bottom of the screen. They
correspond to following features:
: turns the light on and off
manual settings (for setpoint editing and
manual defrost activation)
: display of inputs / outputs and alarms
: if pressed for 3 seconds, it interrupts the
manual cycle.

The manual cycle has no duration settings,
it can only be terminated manually by pressing the
key.
After a default inactivity time, the system goes into
"SCREEN SAVER" mode; the display shows the
values detected by the probes in use.
Just touch the screen to exit the "SCREEN
SAVER" mode. Even the progression of an alarm
may interrupt the "SCREEN SAVER" mode.
9
ENGLISH
GB