Heco CELAN 800 Mode D'emploi page 11

GB
Celan 300: shelf loudspeakers should also be as free-standing as possible, the
distance to the sides and rear to walls and items should be at least
10 cm, the tweeters should be located at ear height.
Y ou should use the supplied spikes when setting the speakers up. This isolates them
from the supporting surface, preventing unpleasant resonance effects. You can choose
between metal and hard rubber spikes for the standing speakers, while the enclosed hard
rubber spikes are used for the shelf speakers. The spikes are screwed into the threaded
bushes on the bottom of the speaker.
The HECO Celan loudspeakers are ideal for use with the Celan Sub 30A or Sub 38A
active subwoofers. Fig. 5 shows a method of connection. Please also refer to the
subwoofer's and your amplifier's operating instructions.
HECO CELAN 300, 500, 700 AND 800 AS A FRONT OR REAR LOUDSPEAKER
The front loudspeakers are positioned at ear height on the left and right as equidistant
from the television as possible. The rear loudspeakers are placed at ear height or a
little above on the left and right besides or better behind the listening position.
Celan 300: if possible, the cross-over frequency for the front and rear channels
should be adjusted to approximately 80 Hz in the AV receiver's set-up.
Otherwise all the recommendations made in the previous chapter also apply.
HECO CELAN CENTER 3
The Celan Center 3 loudspeaker visually and acoustically ideally matches the other
Celan models. The loudspeaker is placed immediately on or under the television set.
The loudspeaker stand provided should to be used for the centre speaker (fig. 8).
Otherwise please adhere to the general recommendations outlined in the previous
chapters.
HECO CELAN SUB 30A AND SUB 38A
The Celan Sub 30A and Sub 38A active subwoofers visually and acoustically ideally
match the other loudspeakers in the Celan series. Please refer to the separate
operating instructions supplied with this product.
11