Publicité
Les langues disponibles
Les langues disponibles
PARTS
ASSEMBLY
CAUTION:
DO NOT insert the mains plug into the mains socket until the fan has been completely assembled. Never
operate the fan with a cracked or damaged fan blade.
Base assembly
1.
Remove the supplied 2 screws from the base.
2.
Insert the fan body into the hole of the base and then press it into the base until it clicks in position.
3.
Fix the base onto the fan body by tightening the supplied screws.
Rear guard assembly
Unscrew the retaining nut from the motor spindle clockwise. Unscrew
the locking nut from the motor spindle anticlockwise.
Position the rear guard onto the motor housing; make sure the handle
on the rear guard is pointing upwards.
Insert the locking nut and turn it clockwise to lock the rear guard into
position.
Fan blade assembly
Slide the fan blade onto the motor spindle, making sure the motor
spindle is fully seated into the blade groove.
Screw the retaining nut anticlockwise to tighten the fan blade to the
motor spindle.
Front guard assembly
Remove the small securing screw and nut from the front guard.
Attention!
The hook of the front guard must be at the top.
Make sure that the holes in both guards are aligned and fasten
them securely by using the provided screw and nut. Once the guard
is in position fasten the clips to finally secure both guards.
10.
11.
Page 10 of 12
1.
Front guard
2.
Retaining nut
3.
Fan blade
4.
Locking nut
5.
Rear guard
6.
Motor spindle
7.
Oscillation knob
8.
Adjusting screw
9.
Control buttons
Base
Securing screws
Locking nut
Publicité
