DEFA SR50A Mode D'emploi page 4

• Please read the manual carefully before use.
• This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of
experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards
involved.
• Do not attempt to charge no-rechargeable batteries.
• Do not use the Standard or 14,7 charging program on a Li-Ion battery or the Li-ion charging battery on a lead-acid battery.
• After use, disconnect the mains power before disconnecting from the battery.
• Only use the charger in well-vented area and on vented batteries.
• This charger has to be repaired by professionals.
• Do not do incorrect connections even though the charge output is protected against short circuiting and wrong connections.
• Do not install the charger in a highly flammable environment.
• Do not charge a damaged battery.
• During charging, battery gas which is very explosive can be developed. Take care not to have sparks, open flames, cigarettes or similar in the vicinity
of the battery and make sure there are sufficient ventilation.
• The acid in the battery is corrosive and harmful. It damages clothes, metal and varnish. In case of spillage and contact with skin, wash and rinse
thoroughly with water and consult a doctor.
• Lead and other chemicals that are used in batteries are toxic. Wash skin and hands thoroughly after working with batteries.
DEFA ShowroomCharger 50A is based on modern switch-mode technology. This charger represent the latest technology within battery charging
and will give the batteries optimum life. It is well suited to charge lead/acid, AGM, EFB, GEL and lithium-ion batteries up to approx.
600 Ah for a unlimited time. The charger can be used with up to 45A parallel consumption at the same time as it charges the batteries.
Read the user guide carefully. If there are any uncertainties, please contact DEFA or a qualified person.
2
ion and data contained in this document are the exclusive property of DEFA AS/
Connect red clamp to (+) and black clamp to (-) or the connection point recommended by the vehicle manufacturer. The charger is intended for use with
lead/acid, AGM, EFB, GEL and Lithium batteries. The battery manufacturer's recommendations shall always be taken into consideration.
Connect the DC charging cable to the charger. See C page 3.
Connect the AC mains cable to the charger. Push the power button once. See B, page 2. The charger will start up and initialize the pre-analyze process.
To turn of the charger, push the power button again.
NOTE: To make sure the correct charging voltages are applied to battery the charging cables must not be shortened or made longer.
4
ABOUT THE CHARGER
3
CONTROL PANEL
No.:
(1)
(1)
(2)
(2)
(3)
(3)
(4)
(5)
(6)
(4)
(5)
(7)
(6)
(8)
(7)
(8)
(9)
(9)
GB
SAFETY
USE
4
Function
Error indicator
Charge level indicator 100%
Charge level indicator 80%
Charge level indicator 60%
Charge level indicator 40%
Charge level indicator 0-20%
Lithium-ion charge program
14,7V charge program
Power button