Andis RBC Manuel D'utilisation page 4

CONNECTING THE CHARGER BASE
1. Remove the wall adapter and charger from the carton.
2. Note the charger comes standard with a universal AC voltage wall adapter and accessory plugs for the
United States and worldwide use. Make sure the proper input plug is attached to the wall adapter.
3. Connect the power cord to the back of the charger and then insert the transformer into an AC outlet.
4. Two or more chargers can be positioned together by sliding the oval shaped tab on one side of a charger
into the matching slot on the side of another, locking them together. This minimizes the counter space
required to accommodate multiple chargers and helps keep the work station orderly (Diagram D).
CHARGING THE BATTERY
1. This battery charger is intended for use with Andis model RBC lithium-ion battery with a rated capacity
of 4.2V 8.4 Wh.
2. Remove the clipper and lithium-ion battery pack from the carton.
3. To remove a battery pack from the clipper, squeeze latches on either side of clipper to release and pull
out battery (Diagram E).
4. Fully charge the battery for one hour before first use. Align the ribs on the front and left back side of
the battery pack with the matching grooves in the charger pocket. Push the battery, contact side down,
firmly into the charging pocket. The button on the front of the charger pops up when the battery pack is
securely inserted in the pocket (Diagram F).
5. The three white lights alongside the charging pocket are charging indicators that display the battery's
approximate charge level. When all three lights are lit, the charging system has completed fast charge
and switched to a reduced charging rate to completely fill the battery. This maximizes safety and battery
life. All three lights remain on for a few additional minutes during this finishing charge. A fully depleted
battery will charge completely in about one hour. The charging indicator lights turn off when the
battery pack is removed from the charging pocket (Diagram G).
6. To remove the battery pack from the charger, push down on the button to release battery pack. Pull the
battery pack from the charging pocket and insert into clipper, noting the ribs on the battery pack align
with grooves inside the clipper (similar to the charger). The battery pack will "click" into place when fully
inserted into the clipper (Diagram H).
RIBS
SLOTS
Diagram C
RIB
SLOT
BUTTON
Diagram F
4
RIB
SLOT
Diagram D
CHARGING CHARGING
INDICATOR INDICATOR
LIGHTS
BATTERY
RELEASE BUTTON
Diagram G
https://manual-hub.com/
SQUEEZE
SQUEEZE
Diagram E
RIB
RIB
SLOT
SLOT
Diagram H