Campbell Hausfeld CL152099 Mode D'emploi page 5

Figure 3 - Wrenches
Always Turn
This Wrench In
The Opposite
Direction
Figure 4
3. Do the opposite of Step 2 to loosen
and change the grinder attachment.
Make sure
attachment stem
is fully inserted into collet opening
and collet is securely tightened.
Loose attachments could fl y off during
operation and cause serious injury. Only
use attachments rated for a minimum of
25,000 RPM.
Maintenance
Release all pressure before
attempting to install, service,
relocate or perform any
maintenance on the air system. Personal
injury and/or property damage could
occur.
STORAGE
The tool must be lubricated before
To Tighten
storing. Follow the air motor lubrication
Collet Turn
instructions with an exception to step
Wrench To The
4. Only run the tool for 2 to 3 seconds
Right
instead of 20 to 30 seconds because
more oil needs to remain in the tool when
storing.
TECHNICAL SERVICE
For information regarding the operation
or repair of this product, please call
1-855-504-5678.
REPLACEMENT PARTS
INFORMATION
For information regarding where to order
replacement parts, call toll free 1-855-
504-5678.
Please provide the following information:
• Model number
• Stamped code
• Part number and description
Address parts correspondence to:
Campbell Hausfeld
100 Production Drive
Harrison, Ohio 45030 U.S.A.
www.campbellhausfeld.com
CL152099
5