Bartscher 700211G Mode D'emploi page 32

Connection
DANGER! Electric shock hazard!
The device can cause injuries due to improper installation!
Before installation and connecting the local power grid specification should
be compared with that of the device (see rating plate). Connect the device only
in case of compliance!
Connect the device only to properly installed single socket with
protective terminal.
Do not disconnect the supply cable by pulling it, always pull the plug.
•
Before use position the device and leave it for at least 2 hours before connecting
to the power supply.
•
After a power outage or after removing the plug from its socket do not connect
the device to a power source for at least 5 minutes.
•
The electrical circuit in the socket must be secured to at least 16A. Only connect the
device directly to the wall socket; do not use any extension cords or power strips.
•
Position the device in such way that the plug is easily accessible for quick
disconnecting when required.
- 31 -