Télécharger Imprimer la page

Outsunny 845-428V01 Instructions D'assemblage page 2

Publicité

ASSEMBLY PREPARATION
EN
Manual del usuario
Please check local building codes regarding footings, location and other requirements
before beginning construction. Study and understand this owner's manual of
important information and helpful tips for easier and more enjoyable assembly.
Assembly instructions:
Reviewing all instructions and the appropriate information before you begin, make
sure following the step sequence carefully for successful results.
Flooring base:
Avoid overhanging trees as much as possible as leaves will make regular cleaning
necessary and broken branches are a potential hazard.
Small trees,bushes or fences nearby can be helpful,acting as a wind break.
The site must be prepared so that the base of the shed is level all round and checking
with a spirit level is required.
The base can be constructed by treated timber or concrete,in order to stop the
moisture getting into the shed,The shed is not designed to be built onto lawn
directly.Also the ground will get muddy during rainy days.
lf a concrete pad is made,it is important that this slopes towards the edges to prevent
water ingress.Time must be allowed for any concrete or cement to dry before building
the shed on top.
Bases can also be constructed from bricks,blocks,or mounted on a concrete pad.
The bricks or blocks should be cemented onto firm and level concrete footings and the
greenhouse frame drilled and screwed to the base.
Parts and Parts List:
Before you start, separate and identify all the parts and hardware to be sure that you
have all the necessary parts for your building (refer to the Parts List Page).
Do not attempt to assemble the building if parts are missing because any building left
partially assembled may be seriously damaged by light winds.
( Please tear off the safety protection layer before the assembly, keep the part
number label if needed )
Safety must be put in the No. 1 position:
1 Select a dry and calm day for your assembly. Team works ( Two or more people ) are
required during the assembly;
2 Wearing safety gloves, eye protection and long sleeves during the assembly to
prevent injury; Pay attention to the sharp edge of some parts;
3 Children and pets are not allowed entering into the construction site;
4 Never concentrate your total weight on the roof of the building. When using a step
ladder make sure that it is safety;
Care & Maintenance:
1 Keep the shed clean with soft cloth, use water if necessary;
2 Keep the door tracks clear of dirt and other stuff that prevent them from sliding
easily.
3 Clean the snow with necessary tools to make sure it is safe to enter into; Heavy snow
may cause
collapse, please make sure safety before entering into.
4 The shed is not made for living but storing stuff.

Publicité

loading