Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
SERVICE AND ADJUSTMENTS
TO REPLACE GROUND DRIVE BELT
(See Figs. 25 and 26)
•
Remove belt guard as described in "TO REMOVE BELT
GUARD".
•
Remove old belt by slipping off engine pulley first then
remove from transmission pulley.
•
Place new belt in groove of transmission pulley and
into engine pulley. BELT MUST BE IN GROOVE ON
TOP OF IDLER PULLEY. NOTE POSITION OF BELT
TO GUIDES.
•
Check belt adjustment as described below.
•
Replace belt guard.
•
Reposition wheel and replace clevis pin and hairpin
clip.
ENGINE
PULLEY
PULLEY
IDLER
TRANS MIS SION
PULLEY
GROUND DRIVE BELT ADJUSTMENT
(See Fig. 26)
For proper belt tension, the extension spring should have
about 5/8 inch (16 mm) stretch when drive control bar is
in "EN GAGED" position. This tension can be attained as
fol lows:
•
Loosen cable clip screw securing the drive control
cable.
•
Slide cable forward for less tension and rearward for
more tension until about 5/8 inch (16 mm) stretch is
obtained while the drive control bar is engaged.
•
Tighten cable clip screw securely.
EXTENSION SPRING
Fig. 26
17
CABLE CLIP
SCREW
DRIVE
CONTROL
CABLE
LESS
TEN SION
MORE
TEN SION
5/8"
Publicité
Chapitres
Table des Matières
