JVC TK-C655 Instructions page 42

Others
Attaching a Ceiling Flush Mount Bracket (Optional WB-S575)
The ceiling flush mount bracket (optional WB-S575) allows the camera to be installed flush with the ceiling surface. In this case the
ceiling material should have a thickness of between 5 mm and 31 mm.
Anchor bolt mount holes
Clamping screw
Clamping
screw
Mount screws (x 4)
(1)
Clamping screw
(2)
Stoppers
Anchor bolt mount
(3)
E-42
Mount hole
3 positions
Loosen
Clamping
bracket
Clamping
screw
1.
Make a hole (diameter 200 mm) in the ceiling.
2.
Prepare the Ceiling Flush Mount Bracket.
• Fully loosen the clamping screws (by turning them counterclock-
wise).
• Move the clamping brackets toward the inside as shown in the
diagram.
• Remove the four mount screws.
3.
Clamp the Ceiling Flush Mount Bracket.
(1) Fit the Ceiling Flush Mount Bracket into the hole in the ceiling.
(2) Ensure that the stoppers are pressing against the back of the
ceiling plate.
(3) Push the Ceiling Flush Mount Bracket all the way up and tight-
en the three clamping screws (by turning them clockwise).
CAUTION
• Make sure that the clamping brackets grip the ceiling plate firmly.
• If the ceiling flush mount bracket rattles after the clamping screws
are tightened, loosen them fully and tighten them again.
If anchor bolts can be used, attach them using M8 - M10 (or 3/8 inch)
nuts.