JVC TK-C655 Instructions page 28

Setting Up the Camera Using an RM-P2580
CAMERA ALC screen (Continued)
Item
B&W/COLOUR
(Continued)
MODE ..
LIGHT TYPE Use this function to set the type of light illuminating the object in the B&W mode.
NORMAL : Setting for normal lighting.
IR
MEMO
If the IR setting is used under ordinary sunlight or fluorescent light, the switching between
the color and B&W modes will not be performed correctly.
HOME MOTION DETECT Screen
When the camera is in the home position:
This screen sets the motion detect function, which outputs an alarm signal when motion is detected in the monitored picture. The
alarm signal is output from the alarm output terminal on the terminal board.
Item
MODE Turns the motion detect function on and off.
OFF : Defeats this function.
ON : Activates this function.
LEVEL Sets the level at which motion is identified.
When the item "MODE" is set to "OFF", this item does not work and "---" is dis-
played as the item name in the HOME MOTION DETECT Screen.
• To detect motions characterized by large changes in the signal level
: Decrease the setting value.
• To detect motions characterized by small changes in the signal level
: Increase the setting value.
Setting values : -5 to NORMAL to 5
MEMO
When the setting value of the detection level is increased, it sometimes causes the fluores-
cent lamp to flicker.
Check the performance at the DEMONSTRATION item after changing the setting.
AREA EDIT.. Sets of the area of the picture within which the motion detect function operates.
☞
P. 36, "HOME MOTION DETECT Setup"
ALARM DISPLAY Sets the length of an alarm signal and the alarm display output when
motion is detected.
When the item "MODE" is set to "OFF", this item is does not work and "---" is dis-
played as the item name in the HOME MOTION DETECT Screen.
Setting values : OFF, 5s, 6s, 7s, 8s, 10s, 15s, 20s, 30s, 60s
MEMO
When the item "MODE" is set to OFF, an alarm signal is output from the alarm output termi-
nal but the alarm display is not shown in the picture.
CAUTION
This item is invalid with the system using the RM-P2580. When using the RM-P2580, use
item "ALARM TIME" instead.
DEMONSTRATION This function is used to confirm the setup of the motion detect function.
MEMO
●
Demonstration function is invalid when the camera is in a position other than the home position.
●
The motion detect function is not activated when the camera is panned, tilted or zoomed in the home position.
●
When the iris or focus operation is performed while the camera is in the home position, the motion detect function is not activated for 5 seconds
after completion of the operation.
●
During auto patrol, the motion detect function cannot be activated even when the camera is in the home position.
E-28
Function & Setting
: Setting for using IR lighting.
Function & Setting
Initial Value
NORMAL
Initial Value
OFF
NORMAL
–
5s
–