Publicité
Les langues disponibles
Les langues disponibles
16
www.electrolux.com
Problem
The appliance door does not close.
The appliance stops during operation.
The cycle time is too long or unsatisfacto‐
ry drying result.
The display shows Err.
The display shows (e.g. E51).
1) After maximum 5 hours, the programme ends automatically.
2) It can happen that some area remains humid when drying big items (e.g. bed sheets ).
If the drying results are not
satisfactory
• The set programme was incorrect.
• The filter is clogged.
• The condenser is clogged.
• There was too much laundry in the
appliance.
• The drum is dirty.
• Incorrect setting of the conductivity
sensor ( See chapter "
1)
Settings -
Possible solution
Make sure that the installation of the filter
is correct.
Make sure that the laundry does not
catch between the appliance door and
the rubber seal.
Make sure that the water container is
empty. Press Start/Pause to start the pro‐
gramme again.
Make sure that the weight of the laundry
is applicable to the duration of the pro‐
gramme.
Make sure that the filter is clean.
The laundry is too wet. Spin the laundry
in the washing machine again.
Ensure that the room temperature is
higher than +5°C and lower than +35°C.
Optimal room temperature is 19°C to
24°C.
Set the Time Drying or the Extra Dry pro‐
2)
gramme.
If you want to set a new programme, de‐
activate and activate the appliance.
Make sure that the options are applicable
to the programme.
Deactivate and activate the appliance.
Start a new programme. If the problem
occurs again, contact the Service.
Adjustment of the remaining laundry
moisture degree " for better setting).
• The airflow slots are clogged.
• Room temperature is too low or too
high ( optimal room temperature 19°C
to 24°C )
Publicité
