Weber Spirit SP320 Mode D'emploi page 26

BURNER TUBE CLEANING
OR REPLACEMENT (continued)
Clean Burner Tubes
You will need: A flashlight, a wire (a straightened-out coat
hanger), a suitable stainless steel bristle brush, and a soft
bristle brush (toothbrush).
A) Look inside each burner tube and Crossover
with a flashlight (1).
B) Clean any debris or blockage from the inside of the
tubes with the wire (2).
C) Check spider/insect screens at the ends of the burner
tubes and clean them using the soft bristle brush (3).
m CAUTION: Do not clean the spider/
insect screens with hard or sharp
tools. Do not dislodge the spider/
insect screens or enlarge the screen
openings.
D) Use the steel bristle brush to clean the outside of the
burner tubes and the Crossover
®
make sure all burner ports (openings) running along
the length of the tubes are fully open. When cleaning
burner tube 1, avoid damaging the igniter electrode by
carefully brushing around it (4).
m CAUTION: Do not enlarge the burner
ports when cleaning.
26
WWW.WEBER.COM
®
ANNUAL MAINTENANCE
1
® tube
2
tube. This is done to
3
4