Bosch LECTUS duo 3000 Serie Mode D'emploi page 32

32 en | Connection
–
–
–
–
2020-10 | V02 |
If the reader is on Wiegand mode, DIP switch 1 must be set
to the OFF position.
If the reader is on OSDP/RS485 mode, DIP switch 1 must
be set to the ON position.
Set the address of the reader by setting the DIP switches 5
to 8 ( Setting the address of the reader (Switch 5, Switch 6,
Switch 7, Switch 8), page 30 ).
Check the wiring between the reader and the controller
( Wiring the reader, page 26 ).
LECTUS duo 3000 readers
Bosch Security Systems B.V.