Bosch LECTUS duo 3000 Serie Mode D'emploi page 28

28 en | Connection
–
–
To change the reader configuration:
1.
2.
3.
Notice!
i
Any changes that are done to the DIP switches while the power
is on are not considered.
3.2.1 Selecting the interface type (Switch 1)
Switch 1
Off
On
2020-10 | V02 |
Enable/disable CSN reading (reads either CSN only or
Bosch code only)
Set the address of the reader
Power-off the reader.
Set the DIP switches correctly.
Power-on the reader.
Mode
Wiegand
RS-485/OSDP The reader uses the RS-485
LECTUS duo 3000 readers
Behavior
The reader uses Wiegand
interface.
It only uses the signals marked
with "Wiegand" interface in
Table 1.
interface with the OSDP
protocol.
It only uses the signals marked
with interface "RS-485" in
Table 1.
Bosch Security Systems B.V.