Miscellaneous - Medisana 40480 Mode D'emploi

GB
3 Operation / 4 Miscellaneous
3.4
Weighing and
measuring body fat,
water content and
muscle mass
3.5
Error messages

4 Miscellaneous

4.1
Care and
maintenance
20
1. Press the SET-button
cation flashes in the display.
2. By pressing the DOWN-
the memory location (0 - 9).
3. Your personal data is displayed.
4. When "0.0 kg" appears in the display, step barefoot onto the
scales andstand still. Place your feet on the electrodes
your weight is displayed. At the same time, the display shows a
moving symbol "
water and muscle mass are being measured.
5. When the "
fixed. The display shows the values measured for the body fat,
water, bodyweight and then the muscle mass, bone weight and
BMI. The series of measured values is repeated twice in the dis-
play. The scales then switch off automatically. Step off the scales.
NOTES
Reliable measurements can only be achieved under
•
certain circumstances, as described in "2.5 Prere-
quisites for correct measuring results", p. 16.
Note that the measured muscle mass contains a
•
certain amount of water, which is included in the re-
sult. The values measured for the water and muscle
mass in your body can therefore not be added
together.
OL
The scale is overloaded.
LO
The battery is low and must be replaced.
ERR
Error during measurement.
---- Data not saved.
•
Remove the batteries before cleaning the unit.
•
Never use aggressive cleaning agents or stiff brushes.
•
Clean the surface and the electrodes after use with a soft, damp
cloth. Never use abrasive cleaning agents or alcohol.
•
Do not allow any water to get into the unit. Do not immerse the
device in water. Do not use the unit again until it is completely dry.
•
Do not expose the unit to direct sunlight; protect it against dirt and
moisture.
•
Do not store the scales upright, as this can cause the batteries to
leak.
•
Remove the batteries from the unit if it will be unused for a long-
ish period. Otherwise there is a risk that the batteries might leak.
3
to switch on the scales. The memory lo-
2
and UP - buttons
", which indicates that your body fat,
" symbol in the display stops, the values are
G
4
you may choose
G
G
6
. First,
G
G
G
G
G
G