Rand McNally intelliroute TND 710 Guide De Démarrage Rapide page 7

Install the mount
noTE:
Follow all local regulations governing the placement of the mount.
Select an area with a line of sight to the sky and GPS satellites to ensure reliable GPS information.
1 Clean and dry the mounting area.
Remove the suction cup protective fi lm.
2
Adjust the angle of the mount using the thumbscrew and slide the mount into the cradle.
3
Pull the suction cup lever up to release suction.
4
Place and hold the mount suction cup against the mounting surface.
5
Press the suction cup lever down until it snaps into place.
6
7 Angle the bottom of the device into the cradle and press the top of the device towards the cradle until you hear the upper clip latch into place.
Plug the power cord into the device and the vehicle's 12-volt power source.
8
9 Adjust the navigation device so that it can be easily seen and does not block the driver's line of sight.
6
TND_710_Booklet_INSIDE_110922.indd 6 9/22/11 2:07 PM