Electrolux TY38TSCN Notice D'utilisation page 76

76 www.electrolux.com
INSTALLATION
WARNING!
Refer to "Safety information" chap-
ter.
Before the installation
Before the installation of the appliance, re-
cord the information below from the rating
plate. The rating plate is on the bottom of
the appliance casing.
• Model ...........................
• PNC .............................
• Serial number ....................
BUILT-IN APPLIANCES
• Only use the built-in appliances after you
assemble the appliance into correct
built-in units and work surfaces that align
to the standards.
CONNECTION CABLE
• The appliance is supplied with the con-
nection cable.
• Replace the damaged mains cable with
a special cable (type H05BB-F Tmax
90°C; or higher). Speak to your local
Service Centre.
TO ATTACH THE SEAL.
• If installing proud of the work surface,
use the sealing tape with dimensions
12x2 mm.
• Clean the worktop in the area of the cut
out section.
ASSEMBLY
All manuals and user guides at all-guides.com
• Cut the one-sided self-adhesive sealing
tape supplied into four parts according
to the edge length of the cut-out and
stick to the worktop along the edge of
the cut-out. In doing so, the sealing tape
should protrude by approx. 3 mm over
the edge of the appliance on all sides.
• Do not stretch the sealing tapes when
sticking. Do not stick the ends on top of
each other, these should be pushed
against each other.
• After fitting the Teppan Yaki (using the
provided fitting material), the overlaying
sealing tape must be cut away on all
sides using a sharp knife. Take care not
to damage the worktop.
TO ATTACH THE SEAL TO THE
RABBET
• Clean the rabbet in the work surface.
• Bond the seal stripe supplied on the up-
per surface of the rabbet along the
edges of the cut out section.
• Cut the seal stripe into four pieces in re-
lation to the length of the edges of the
rabbet.
• For the four corners of the rabbet the
ends of the seal stripes must be cut into
mitres. Do not bond the ends over one
another.
• Bond the seal stripe flush into the corner
of the rabbet. Make sure that no silicon
compound can get below the appliance
when grouting.
min.
500mm
min.
50mm
min.
50mm
min.
5mm