SilverCrest SNS 45 A2 Mode D'emploi page 78

GB
76
NOTICE
► Under no circumstance should you now touch the nail surfaces with your
fi ngers, if you do, they will become greasy again and this will prevent a
good bonding!
Apply a small drop of nail glue a to the lower part of the nail tip o and
distribute it with the aid of the nail glue bottle a on the lower surface. Hold
the nail tip o down so that the nail glue a cannot run onto the upper part
of the nail tip o.
NOTICE
Before the fi rst use you must puncture the bottle of nail glue a with a
►
pointed object, such as a needle. If, at a later date, the bottle of nail glue
a has become blocked, it can again be opened for use with a needle.
Now place the nail tip o at an angle on the natural nail, so that the predeter-
mined edge of the nail tip o lies on the edge of the natural nail.
Now tilt the nail tip o with gentle pressure onto the natural nail, so that po-
tential air bubbles are squeezed out .
o
NOTICE
Wipe excess nail glue a off with a cotton swab or a paper towel.
►
Hold the nail tip o fi rmly for 10-12 seconds and, at the same time, press it
down with suffi cient pressure onto the natural nail. Ensure that no air bubbles
are formed and that the tip is glued on perfectly straight.
a
SNS 45 A2