Far Tools GGB 950 Notice Originale page 33

FUEL TAP
1- Shut down the motor
2- Remove the plate
3- Turn the supply cock lever to «OFF».
4- Remove the tray from the fuel cock and the seal
5- Clean the tray using a solvent and dry it
6- Check the seal and replace it if it is damaged
7- Reassemble the seal, tray and plate.
Do not wring out the element. This could cause it to lear. The engine should never run
!
without the element; excessive piston and cylinder wear may result.
Never use solvent while smoking or in the vicinity of an open flame.
Never use or be near the fuel and solvent while smoking or in the vicinity of an open
!
flame. be sure the fuel cock cup is tightened securely.
FUEL TANK FILTER
1- Remove the fuel cap tank and filter.
2- Clean the filter with solvent. If damaged, replace.
3- Wipe filter and insert it.
!
be sure the fuel cock cap is tightened securely.
118015-Manual-Findd 33
© FAR GROUP EUROPE
EN
10/06/13 14:12:46