Publicité
Les langues disponibles
Les langues disponibles
en-us Installation Procedure
Drive the mounting screws through the holes inside the
4.
dishwasher.
Re-insert the cutlery rack.
5.
4.9 Attach the 2-part Toe Panel
If your dishwasher has a rubber apron, install the 2-part
1.
toe panel behind the apron.
Place the slotted toe panel on the dishwasher.
2.
It should rest on the floor.
‒
Position the mating front toe panel on top of the rear toe
3.
panel with the angled edge on the mating edge of the
dishwasher.
To secure the toe panels, drive the two black torx
4.
screws through the holes in the toe panel and the
dishwasher base.
To avoid damaging the dishwasher, use the supplied
‒
screws.
4.10 Attach the Outer Toe Panel
NOTICE:
Avoid door interference
To ensure the door can open and close without any
▶
interference, check the clearance when installing the
outer toe panel.
12
Slide the supplied brackets into the slots of the toe
1.
panel you just attached.
To ensure that the outer toe panel is flush with the
2.
cabinetry base, determine the correct position for the
brackets.
Mark the correct position, then slide the brackets out
3.
and bend out the metal tab at the correct position.
Bending a tab ensures that the toe panel cannot slide in
further.
Re-insert the brackets.
4.
Secure the outer toe panel with the crosshead screws
5.
provided.
The outer toe panel should completely cover the
‒
rubber apron.
Publicité
