Domo DO923K Mode D'emploi page 36

· Allow 13 cm of space between the back of the refrigerator and any adjacent wall.
· Avoid direct sunlight and heat. Direct sunlight may affect the acrylic coating. Heat sources
nearby will cause higher electricity consumption.
· Avoid very moist places. Too much moisture in the air will cause frost to from very quickly
on the evaporator, and your refrigerator.
· Before connecting your refrigerator to the power supply, check that the voltage stated
on the rating label of your appliance corresponds to the voltage in your home. A different
voltage could damage the appliance.
· For uneven surfaces, front feet can be aligned.
· After installation, leave the freezer for 12 hours before turning it on. This way the
refrigerant can settle.
USE
AMBIENT TEMPERATURE
This appliance is designed to operate in ambient temperature between 16°C and 38°C.
If these temperatures are exceeded, i.e. colder or warmer, the appliance will not operate
correctly. If the ambient temperatures are exceeded for long periods, the temperature in the
fridge will rise above 4°C and food spoilage may occur.
TEMPERATURE CONTROL
The fridge is controlled with a temperature control knob located inside the appliance.
Adjust the control knob as desired to suit your individual preference. The higher the number,
the colder the temperature. Position 4 is the recommended position for normal use.
· In the 0 position the appliance does not operate (the cooling system is switched off), but
power supply is not interrupted.
· The running time and temperature are affected by where the fridge is located, how often
the door is opened and the temperature of the room the fridge is located in.
MOVING YOUR APPLIANCE
· If the appliance is turned off for any reason, wait for 10 minutes before turning it back on.
This will allow the refrigeration system pressures to equalise before restarting.
· Turn off the appliance and unplug it from the mains socket. Remove all food. Also remove
all mobile parts (shelves, accessories, etc.) or fix them into the fridge to avoid any shock.
· Relocate and install. If the appliance has been left on its side for any length of time, leave it
standing upright for at least 10 minutes before turning on.
36
DO923K