Publicité
Les langues disponibles
Les langues disponibles
PARTS
1.
Temperature control knob with LED
lighting
2.
Shelves
3.
Cover for vegetable container
4.
Vegetable container
5.
Levelling feet
6.
Handle
7.
Door shelves
8.
Door bottle shelf
9.
Door
INSTALLATION
·
Remove the exterior and interior packing, wipe the outside thoroughly with a soft dry cloth and the
inside with a wet, lukewarm cloth. Dry the appliance off well.
·
Let air circulate freely around the cabinet. Allow 10 cm of space between the back, the top side and
both sides of the refrigerator and any adjacent wall.
·
Make sure there is sufficient space to open the door.
·
This cooling unit is not intended for use as a built-in appliance.
·
Select a place with a strong, level floor.
·
Avoid direct sunlight and heat. Direct sunlight may affect the acrylic coating. Heat sources nearby will
cause higher electricity consumption.
·
Avoid very moist places. Too much moisture in the air will cause frost to from very quickly on the
evaporator, and your refrigerator.
·
Before connecting your refrigerator to the power supply, check that the voltage stated on the rating
label of your appliance corresponds to the voltage in your home. A different voltage could damage the
appliance.
·
After installation, leave the freezer for 24 hours before turning it on. This way the refrigerant can
settle.
·
Allow the appliance to run empty for 8 hours so the compartment can cool to the appropriate
temperature.
·
One can level the appliance using adjustable legs. The adjustable legs can be adjusting by screwing
them in or out of the appliance.
www.domo-elektro.be
39
DO91920
Publicité
