Powerplus POWDP75300 Traduction Du Mode D'emploi D'origine page 39

▪
Though poor conditions of the electrical mains, shortly voltage drops can appear when
starting the equipment. This can influence other equipment (eq. blinking of a lamp). If the
mains-impedance Zmax <0.348 Ohm, such disturbances are not expected. (In case of
need, you may contact your local supply authority for further information.
▪
Make sure that the accessories used are suitable for the maximum speed stated in the
technical data.
▪
Make sure that the accessories are mounted according to the instructions.
▪
Only use accessories and adapters supplied by the manufacturer.
▪
Make sure that sparks cannot hit any persons or set flammable materials alight.
▪
Always wear safety goggles, hearing protection and if necessary other protective means,
such as working gloves, hard hat, etc.
6.1 Additional safety instructions
Do not use the tool on light metal with a magnesium content exceeding
80%, as this type of metal is flammable.
The work head may continue rotating after the tool is turned off
On the upper side of the tool there is a spindle-lock button. Do not press
the spindle-lock button while the tool is running
▪
Make sure that the accessories used are suitable for the maximum speed stated in the
technical data.
▪
Make sure that the accessories are mounted according to the instructions.
▪
Only use accessories and adapters supplied by the manufacturer.
▪
Make sure that sparks cannot hit any persons or set flammable materials alight.
▪
Always wear safety goggles, hearing protection and if necessary other protective means,
such as working gloves, hard hat, etc.
7 ADDITIONAL SAFETY INSTRUCTIONS FOR BATTERIES AND
CHARGERS
Use only batteries and chargers applicable for this machine.
7.1 Batteries
▪
Never attempt to open for any reason.
▪
Do not store in locations where the temperature may exceed 40 °C.
▪
Charge only at ambient temperatures between 4 °C and 40 °C.
▪ When disposing of batteries, follow the instructions given in the section "Protecting the
environment".
▪
Do not cause short circuits. If connection is made between the positive (+) and negative (-)
terminal directly or via accidental contact with metallic objects, the battery is short circuited
and an intense current will flow causing heat generation which may lead to casing rupture
or fire.
▪
Do not heat. If batteries are heated to above 100 °C, sealing and insulating separators
and other polymer components may be damaged resulting in electrolyte leakage and/or
internal short circuiting leading to heat generation causing rupture or file. Moreover do not
dispose of the batteries in fire, explosion and/or intense burning may result.
▪
Under extreme conditions, battery leakage may occur. When you notice liquid on the
battery, proceed as follows: carefully wipe the liquid off using a cloth. Avoid skin contact.
Copyright © 2022 VARO
POWDP75300
P a g e | 7
EN
www.varo.com