Troubleshooting; Specification; Technical Specifications - Furrion F1S17L02A-BL Manuel D'utilisation

Troubleshooting

Before calling for service, review this list. It may save you both time and expense. This list includes common experiences that
are not the result of defective workmanship or material in your appliance.
Problem
Surface Control Knob has not been completely turned to
until burner ignites and then turn control to desired flame size.
Surface burners do not
Ensure gas supply valve is open.
light
Burner ports or slots are clogged. With the burner off, use a small-gauge wire or needle to clean ports or slots.
Low gas supply level in cylinder.
Moisture is present on the burner, dry burner thoroughly.
Surface burner flame
Burner ports or slots are clogged. With the burner off, clean ports with a small-gauge wire or needle to clean ports or slots.
burns half way around
Moisture is present after cleaning. Lightly fan the flame and allow burner to operate until flame is full. Dry the burners thoroughly.
Dust particles in main line. Allow the burner to operate a few minutes until flame turns blue.
Surface burner flame
is orange
In coastal areas, a slightly orange flame is unavoidable due to salt air.
Control LED only stays
The igniter knob control will not change color (Far Left control knob). All other knobs will change to RED when the control is
BLUE turned on;
Control knob stays
Knob LED PCB Hall components fail to sense the magnet. Contact Furrion for service.
RED at OFF position

Specification

Optional Power Gas power
Left and Right Burner: 6500 BTU
BTU/HR Front Burner: 8000 BTU
Oven: 7100 BTU
Fuel / Power Propane
Inlet Pressure 10" WC Min to 13.8" WC Max
Power Input 12V DC < 2 Amp
17" Range Oven: 35L
Inner Volume of
the Oven
21" Range Oven: 51L
This appliance conforms with the directives: ANSI Z21.57a-(2012) Rec / CAN1-1.16-M79 (R2011)
18
Possible Causes / Solution
position. Push in and turn the Surface Control knob to

Technical Specifications

position