Hitachi NV 65AD3 Mode D'emploi page 8

English
Hammer
Rod
Nail outlet
(3) Cut off the defective part of the steel wire which links
the nails with cutting nippers, correct the deformation,
then load the nail roll in the magazine.
(4) In case of frequent jams, consult the Authorized Service
Center from which you bought this machine.
2. Check on mounting screws for each part
At regular intervals check every part for loose
mounting screws and whether or not there are any
air leaks. Retighten any loose screws. Operating the
equipment with loose screws untightened will incur
a hazard.
3. Inspecting the push lever
Check if the push lever can slide smoothly. (Fig. 16)
Clean up the sliding area of the push lever and use the
provided oil for lubrication from time to time.
Lubrication enables
simultaneously serves to prevent the formation of
rust.
7
Nail Guide
Fig 14
Slotted-head
screwdriver
Fig 15
smooth sliding
Nose
Push lever
4. Inspecting the feeders
(1) Occasionally clean the knob sliding part and then
apply the recommended oil. (See Fig. 17)
(2) Open the nail guide and remove dust, etc., as shown
in Fig. 18. Apply lubricant to the sliding groove of the
feeder and feeder shaft. Check the main nail stopper
and sub nail stopper slide smoothly by pushing them
with your finger.
Nail
and
Guide
Sub Nail Stopper
Lubricate
Fig. 16
Knob
Nail Guide
Fig. 17
Main Nail Stopper
Feeder Shaft
Feeder
Fig. 18