Ariston AS5E4PHW/MEA Manuel D'utilisation page 21

REMOVING AND REFITTING THE DOOR
1.
To remove the door, open it fully and lower the
catches until they are in the unlock position.
2.
Close the door as much as you can.
Take a rm hold of the door with both hands – do not
hold it by the handle.
Simply remove the door by continuing to close it
while pulling it upwards (a) at the same time until it is
released from its seating (b).
~60°
Put the door to one side, resting it on a soft surface.
3.
Re t the door by moving it towards the oven,
aligning the hooks of the hinges with their seating
and securing the upper part onto its seating.
4.
Lower the door and then open it fully.
Lower the catches into their original position: Make
sure that you lower them down completely.
5.
Try closing the door and check to make sure that it
lines up with the control panel. If it does not, repeat
the steps above.
1.
After removing the door and resting it on a soft
surface with the handle downwards, simultaneously
press the two retaining clips and remove the upper
edge of the door by pulling it towards you.
2.
Lift and rmly hold the inner glass with both
hands, remove it and place it on a soft surface before
cleaning it.
3.
When reassembling the inner door glass
~15°
insert the glass panel correctly so that the
text written on the panel is not reversed
b
and can be easily legible.
a
4.
Re t the upper edge: a click will indicate correct
positioning. Make sure the seal is secure before
re tting the door
EN
21