Auriol 4-LD5009 Mode D'emploi page 43

Securely placing or mounting the weather station
The weather station with outdoor sensor is not designed for operation in rooms
with high humidity (i.e. bathroom). Use the included screws and anchors for wall
mounting. Make sure that:
 sufficient ventilation is always guaranteed (don't place the device on shelves or
where curtains or furniture block the ventilation holes, and ensure that there are
at least 10 cm of space on all sides);
 the device isn't placed on a thick carpet or bed during operation, no direct heat
sources (i.e. radiators) influence the device;
 no direct sunlight reaches the device;
 contact with splashing or dripping water must be avoided (don't place any items
filled with liquids, i.e. vases, onto or next to the device);
 the device doesn't stand near magnetic fields (i.e. speakers);
 no foreign objects or dust penetrate the housing;
 candles and other open flames must be kept away from this product at all times
to prevent the spread of fire
Securely placing or mounting the outdoor sensor
Place the sensor in a location where it is protected from the weather, for example
under an awning or carport. The sensor has an IPX4 rating and is therefore
protected from water splashes. Use the included screws and anchors for wall
mounting. Make sure that:
 the sensor hangs or stands upright;
 sufficient ventilation is always guaranteed (don't place the device on shelves or
where curtains or furniture block the ventilation holes, and ensure that there are
at least 10 cm of space on all sides);
 no direct sunlight reaches the device;
 the device doesn't stand near magnetic fields (i.e. speakers);
 no foreign objects or dust penetrate the housing;
Setup
Insert batteries into the outdoor sensor 43 first and then
insert batteries into the weather station 37.
Remove the protective film from the weather station and the outdoor sensor. Open
the battery compartment of the outdoor sensor 43 and insert the included batteries
in the correct polarity. The LED indicator 47 will briefly light up and the display will
show the temperature. Close the battery compartment.
Open the battery compartment of the weather station 37 and insert the included
batteries in the correct polarity. Close the battery compartment. The weather
symbol 6 6 6 6 blinks and the weather station receives the signal from the outdoor
sensor. This process may take several minutes to complete. During this time the
signal 3 of the outdoor sensor will blink. If reception is successful, the selected
channel 23 and the current outdoor temperature 2 will appear. After successful
reception of the signal for the outdoor sensor, the reception of the DCF77 time
signal will begin and the radio control indicator 19 will blink on the display next to
the time. All buttons except the SNOOZE / LIGHT button 5 are disabled during
the reception process. If reception fails after 10 minutes, please set the time
manually. The weather station will reattempt reception at 04:00 and 05:00 and, if
reception is successful, will correct the set time.
Note: Please do not move the weather station or the sensor during the reception
process.
If the reception attempt is successful, the radio control indicator 19 will appear
permanently on the display and the correct time, date, day of the week and the
times of sunrise, sunset, moonrise and moonset will be set automatically. DST will
appear on the display next to the radio control indicator 19 during daylight saving
time.
Time zone adjustment
If you are in a country, in which the clock displays the wrong time even though it
can receive the time signal, please use the time zone adjustment to use your
weather station in a time zone other than the standard time zone (UTC+1 = Central
European Time). Set the difference in hours (- 01 for example) to the desired time
zone.
- 41 -