Chain Oil System - Scotts S20500 Manuel D'utilisation

WARNING:
To avoid serious personal injury, always remove
the battery pack and keep hands clear of the
trigger lock-out when carrying or transporting
the tool.
To remove:
 Locate latches on side of battery pack and
depress both sides to release the battery pack
from the chain saw.
NOTE: It is not necessary to remove the battery
pack from the tool to recharge.
WARNING:
If charging with the battery installed on the tool,
make sure that charger is mounted high enough
to prevent unauthorized activation of the tool.
Unauthorized activation of the tool can result in
serious personal injury.
 With the battery installed, place the tool in the
wall-mounted charger by aligning the raised
ribs on the tool housing with the grooves in the
charger as shown.
 Slide the tool down until it is fully seated on the
charger.
WARNING:
When charging the battery while installed on
the tool, always make sure to install the scab-
bard. Failure to do so could result in serious
personal injury.

CHAIN OIL SYSTEM

See Figure 7.
NOTICE:
Fill oil tank with bar and chain lubricant (not
provided) before starting the chain saw. Failure
to lubricate the chain will cause damage to the
bar and chain.
 Use bar and chain lubricant formulated to per-
form over a wide temperature range with no
dilution required.
OPERATION
BATTERY
PACK
15 — English
LATCHES
BATTERY
PORT
LATCHES
BATTERY
FUEL GAUGE
Fig. 5
Fig. 6
Fig. 7