Publicité
Les langues disponibles
Les langues disponibles
• UNPACKING
o This product has been packaged to protect it against transportation damage. Keep
the original manual, packaging carton and materials in a safe place. It will help
prevent any damage if the product needs to be transported in the future or handed
to others.
o In the event it is to be disposed of, please recycle all packaging materials where
possible.
o Remove unit from box and tape and glue residue from surfaces before turning on the
appliance.
o Unwind the cord fully and inspect it for damage.
o Do not use the appliance if any part is damaged. In case of damage, contact your
after sales service.
• INSTALLATION
General information
o When moving the machine, make sure that it is in an upright position.
o Do not install the air conditioner in a room where frost may occur. There is a risk of
damage if the condensate water freeze in the device or its pipe.
o While adjusting the upper and lower wind-guide strips of the air outlet, pluck it with
hands gently to avoid damaging wind-guide strips.
Instructions
Select mounted place
Install the air conditioner in a flat and dry place, with a
o
minimum clearance of 50 cm around the unit to enable
smooth circulation of air, as shown in Fig. 3 (before
connection of exhaust pipe).
Assembly method of exhaust pipe (For COOL Mode)
Extend either side of the pipe and screw the pipe to adaptor
o
(Fig. 4).
Insert the round ending of the exhaust pipe into the rear air
o
outlet of the air conditioner, as shown in Fig. 5.
Connect the oval ending of the connected exhaust pipe with
o
the window slide bar connector.
Gebrauchsanweisung ○ Mode d'emploi ○ Istruzioni per l'uso ○ Instructions for use
56
Fig. 3
Fig. 4
Fig. 5
Publicité
