Bestron ABG200YB Mode D'emploi page 24

cleAninG And MAintenAnce - changing the dust bag
1. C hange the dust bag immediately once the
'dust bag full' indicator turns red, see Figure 8.
I t is possible that the indicator turns red whilst
the dust bag is not yet full. if so, then the nozzle,
hose or tubes may be blocked. These will then
need to be cleaned.
2. O pen the cover by pulling the cover release
(dust bag) upwards. Remove the dust bag from
the holder, and dispose of it in a dustbin.
3. F it a new dust bag in the holder with the arrow pointing downwards, and press into position.
4. Close the cover, and press until it clicks into place.
M ake sure that the dust bag does not become pinched by the cover. This could damage the appliance
and/or the dust bag.
Note Dust bags for this vacuum cleaner are available from every major hardware store.
cleAninG And MAintenAnce - cleaning or replacing the motor safety filter
Clean or replace the motor safety filter at least twice a year, and more frequently if the filter is visibly blocked.
1. Remove the plug from the wall socket.
2. Remove the hose from the vacuum cleaner.
3. O pen the cover by pulling the cover release
(dust bag) upwards. Remove the dust bag,
see Figure 10. Remove the motor safety filter
holder, located behind the dust bag: see Figure
9
.
4. D ispose of the filter, or wash it in lukewarm
water. Allow it to dry thoroughly.
5. R eturn the cleaned or new filter to its holder, and fit the holder in the appliance. Fit a dust bag. Close the
cover, and press until it clicks into place.
• W ater could penetrate into the appliance if the filter is not thoroughly dry. This could result in
(electrical) damage.
• M ake sure that the dust bag does not become pinched by the cover. This could damage the appliance
and/or the dust bag.
cleAninG And MAintenAnce - replacing the exhaust filter
Replace the exhaust filter at least twice a year, and more frequently if the filter is visibly blocked.
1. Remove the plug from the wall socket.
2. O pen the exhaust-filter cover by pulling on the lip on the cover. Remove the exhaust filter from the
appliance, see Figure 10
.
3. R inse the filter in lukewarm water. Allow it to dry thoroughly.
4. R eturn the cleaned filter to the appliance. Close the cover, and press until it clicks into place.
24
user's instructions