Amplicomms HS 1200 Mode D'emploi page 24

G G
ERÄTE IN ETTING STARTED
Set up the receiver
Charging and installing the batteries
1 Open the charging compartment on the
transmitter and insert 2 rechargeable
batteries. Make sure they are aligned
with the correct pole (markings in the
battery compartment). The charging dis-
play will be lit red while the batteries are
charging (approx. 5 hours). When the
batteries are fully charged, the charging
light will turn green.
2 Take the now fully charged batteries
from the charging compartment on the
transmitter and put them in the receiver.
Open the battery compartment by relea-
sing the lock and inserting the fully
charged batteries. Make sure they are
aligned with the correct pole (markings
in the battery compartment).
Close the battery compartment.
• Prior to initial use, charge the batteries in the charging compartment
on the transmitter and then insert the fully charged batteries into the
receiver.
• Charge the reserve batteries in the charging compartment on the
transmitter so fully charged batteries are always available.
• Fully charged batteries provides up to 8 hours of listening enjoy-
ment.
• To conserve battery power, the receiver automatically shuts off if no
signal is detected for a period of approx. 5 minutes or when the level
is too low. However, if the signal returns to an acceptable level, the
transmitter will automatically switch ON again.
20
B
ETRIEB NEHMEN
Helpline UK 0844 800 6503
(See page 29 for costs and hours of operation)