Gaggia RI8157/40 Mode D'emploi page 9

Description of parts:
FIG. 01
1 Main switch
Hot water/brew switch (pump)
2
On/off light
3
Steam switch (temperature)
4
Correct temperature light
5
Removable water tank
6
7 Steam/hot water knob
Turbo frother steam nozzle (removeable)
8
Filterholder
9
1 cup filter
10
2 cup filter
11
Basin (removable)
12
"Perfect crema" Filter (OPTION)
13
14 Brewing head
Filterholder gasket
15
Shower disc holder
16
Shower disc
17
Tamper
18
Power cable and plug
19
20 Measuring spoon
Delivery spout
21
Tank cover
22
Grid (removable)
23
Cappuccino maker kit (OPTION)
24
Overflowing protection hole
25
26 Anti-fingerprint cleaner for stainless steel
Level indicator for the basin
27
Coffee pod filter
28
Instructions for the power supply cord
A A short power-supply cord is provided to
reduce risks of getting tangled up or tripping
over a longer cord.
B Longer extension cords are available and
may be used if care is exercised in their use.
C If a long extension cord is used:
1 the marked electrical rating of the extension
cord should be at least as great as the electri-
cal rating of the appliance.
2 if the appliance is of the grounded type, the
extension cord should be a grounding-type
3-wire cord, and
3 the longer cord should be arranged so that it
will not drape over the counter top portable
top where it can be pulled on by children or
tripped over.
Preparation:
1. Remove the water tank cover (22) and fill
with cold water to the MAX line indicated
on tank (6). See FIG. 2.
N.B.: Near the word MAX on the tank there is
the overflowing safety hole (25) in case of
tank overfilling.
The water tank can also be removed, after
removing the tank cover (22) using the
handle.
Re-install tank with water and cover (22).
2. Insert plug (19) into a suitable wall outlet (see
point 1 under "Caution").
3. Turn the power switch (1) to "On". The on/off
light (3) will switch on.
Make certain that the hot water/coffee switch
(2) and that the steam switch (4) are in the
"Off" position.
Starting up
This procedure fills the water boiler with fresh
water.
This should be done whenever the machine is
switched on.
This machine, featuring a pump to brew coffee,
is equipped with a self-priming system. Place an
empty cup under the brewing head (14), do not
insert filter holder and press hot water/coffee
switch (2) (pos. "On").
You will hear the sound of the operating pump
and after few seconds, water will start to escape
from the brewing head (14).
• 9 •
ENGLISH