Annovi Reverberi HPJ 8.12 REG EM Manuel D'utilisation Et D'installation page 35

Safety recommendations for installation
All installation phases
consideration when designing the machine or system
in which the pump is to be installed.
The design must consider all mounting points, the
means for transmitting the energy sources, and
the protective and safety devices required by the
relevant regulations to prevent the risk of injury.
Check that the electric pump's "IP" protection level is
suitable for the application.
The installation and connections must be done
following the manufacturer's instructions (layout,
Installation
Do not install the electric pump in a position where it will be directly exposed to atmospheric agents.
Install the electric pump in an area where ventilation is not obstructed.
Some examples with proper ventilation are shown in the illustration below.
UN004320-GM
English
INSTALLATION INSTRUCTIONS
must be taken into wiring diagrams, etc.) by specialised and authorised
personnel having
electrical, hydraulic) who must also take into
account all legislative requirements and applicable
regulations.
Take all possible precautions to allow the pump to be
installed in a safe, risk-free manner.
After installation, check that the regulatory and
safety requirements have been met before operating
the electric pump.
35
specific skills (mechanical,
Use and Installation
5