Atag WV9211NM Notice D'utilisation page 55

INSTALLATION
Montage
255
Drilling the support surface and fitting the Hood
• The hood can be fitted directly on the lower surface of the wall units
(at minimum 650 mm above the cooker top) using the snap-on Side
Supports.
• Make an opening on the lower surface of the wall unit, as indicated.
• Screw the closing profile 20 onto the rear part of the hood, using
the screws 12e (2.9 x 12.7) provided.
• Open the glass panel.
• Remove the metal grease filters one by one by turning the hooks
provided.
• Close the glass again.
• Insert the hood until the snap-on side supports click into place.
• Open the glass panel.
• Lock in position by tightening the screws Vf from underneath the
hood.
Vf
EN 13