Wiring Connection - Kenwood KDC-X303 Guide De Démarrage Rapide

Installing the unit (without mounting sleeve)
1
Remove the mounting sleeve and trim plate from the unit.
2
Align the holes in the unit (on both sides) with the vehicle
mounting bracket and secure the unit with screws (supplied/
commercially available).
Removing the unit
Part list (supplied)
(A) Faceplate (×1)
(B) Trimplate (×1)
(C) Mounting sleeve (×1)
(D) Wiring harness (×1)
(E) Extraction key (×2)
Use only the specified screws.
Using wrong screws might damage
the unit.
(F) Screw (supplied for
/
M5 × 7 mm (×4)
M5 × 6 mm (×4)
M4 × 8 mm (×1)

Wiring connection

Fuse (10 A)
a Brown: To connect the
KENWOOD navigation system,
refer your navigation manual
b Blue/white: To the power
control terminal when using
the optional power amplifier
or to the antenna control
terminal in the vehicle
/
c Light blue/yellow: To the
)
steering wheel remote control
adapter or to KENWOOD
Marine Remote Control
unit (optional accessory) for
Antenna terminal
If no connections are made, do not
let the wire come out from the tab.
Car fuse box
Ignition switch
Car fuse box
Battery
d Red: Ignition 12 V
e Yellow: Battery 12 V
f Black: Ground
g White ª, White/black ·:
Front speaker (left)
h Gray ª, Gray/black ·:
Front speaker (right)
i Green ª, Green/black ·:
Rear speaker (left)
j Purple ª, Purple/black ·:
Rear speaker (right)
3