Aircare CM330 Serie Guide D'utilisation Et D'entretien page 6

The analog units have a variable humidistat that ranges from 20"% to 80%.
MODELS CM330D (DIGITAL CONTROL PANEL)
The Digital units have a 3-level humidistat with 25%, 45% and 65% set points.
NOTE: If excessive condensation forms on wall or windows, reduce fan to a lower
speed setting or change location.
CARE AND MAINTENANCE
Cleaning your humidifier regularly helps eliminate odors and bacterial and
fungal growth. Ordinary household bleach is a good disinfectant and can be used
to wipe out the humidifier base and bottle/reservoir after cleaning. We recommend
cleaning your humidifier whenever changing the
Essick Air ® Bacteriostat Treatment each time you refill your humidifier to eliminate
bacterial growth. Add bacteriostat according to the instructions on the bottle. Please
call 1-800-547-3888 or visit www.aircareproducts.com to order Bacteriostat
Treatment, part number 1970.
STANDARD CLEANING
1) Turn off unit completely and unplug from outlet.
2) Lift off chassis from base and set aside. Carry base to cleaning basin/sink.
Remove and dispose of used wick.
3) Empty base into sink. Remove any remaining water from base with a sponge.
4) Fill base to "MAX FILL" line with water and then add 8oz (1cup) of white vinegar.
Let solution stay 20 minutes, then empty.
5) Clean all interior surfaces of base with a soft brush. Dampen soft cloth with white
vinegar and wipe out base to remove scale.
6) Rinse base thoroughly with fresh water and remove scale and cleaning solution.
DISINFECTING UNIT
7) Fill the base ½ full with water and add 1 teaspoon of bleach. Let solution stay for
20 minutes, then rinse with water until bleach smell is gone. Dry interior surfaces
with clean cloth. Wipe down the outside of the unit with a soft cloth dampened
with fresh water.
8) Refill unit and reassemble per ASSEMBLY instructions.
SUMMER STORAGE
1) Clean unit as outlined above.
2) Discard used wick and any water in the reservoir. Allow to dry thoroughly before
storage. Do not store with water inside reservoir.
3) Do not store unit in an attic or other high-temperature area, as damage is probable.
4) Install new filter at beginning of season.
1) Turn the unit on by pressing the Power button.
2) Press the fan button to adjust the fan speed. The
indicator lights above will illuminate to indicate High,
Medium and Low speed.
3) Press the humidity button to increase the humidity
level. The indicator lights above will indicate low,
medium or high humidity selection.
6
wicks. We also recommend using