Dyna-Glo EG4000DG Instructions D'installation Et D'entretien page 4

Any other servicing should be performed by qualified service personnel.
WALL OR CEILING MOUNTING
THE EG4000DG OR EG4800DG OR EG5300DG IS SUPPLIED WITH A WALL OR CEILING MOUNTING
BRACKET, MODEL EG4000DG OR EG4800DG OR EG5300DG, THE BRACKET SHOULD BE MOUNTED TO
A STRUCTURE THAT IS CAPABLE OF SUPPORTING THE BRACKET AND HEATER COMBINED WEIGHT.
IDEALLY THE BRACKET SHOULD BE BOLTED TO A WALL STUD, ROOF TRUSS OR TO A BLOCK WALL
USING THE PROPER MOUNTING HARDWARE. THE HEATER SHOULD BE MOUNTED AS CLOSE TO THE
RECEPTACLE AS POSSIBLE TO ELIMINATE THE USE OF AN EXTENSION CORD.
Drill two holes in a wall/ceiling, the distance of the holes should match the bracket. Screw two M10*30 screws
(not included in samples) to wall/ceiling, male sure the bracket is secured, hung the heater as below photo, let
the hand-driven (provide with sample) go through installation opening. Secure the screw by a nut.
Mount with bottom of heater at least 2.4 m above floor or grade.
CAUTION: MOUNT WITH BOTTOM OF HEATER AT LEAST 2.4 m ABOVE FLOOR OR
GRADE ATTENTION : INSTALLER À AU MOINS 2,4 m DU PLANCHER.
CAUTION
4
4