Sharp LL-B220 Mode D'emploi page 13

Menu item details
The menu will differ depending on the input mode.
nPICTURE
BRIGHT
Adjust the backlight brightness.
CONTRAST
Adjust the difference between the bright and dark portions of
the image.
H-POS (D-SUB)
Adjust the horizontal position of the image.
V-POS (D-SUB)
Adjust the vertical position of the image.
PHASE (D-SUB)
Adjust sampling clock phase for applicable video.
CLOCK (D-SUB)
Adjust frequency for sampling for applicable video.
nCOLOR ADJUSTMENT
WHITE BALANCE
Set the white balance.
When choose USER, adjustment of each contrast for R, G
and B is available.
LOW BLUE LIGHT
When WHITE BALANCE is LOW BLUE LIGHT, the reduce
ratio of blue light can be set. This is only available in case
WHITE BALANCE is LOW BLUE LIGHT.
nINPUT
INPUT
Select the input signal.
WIDE MODE
Set whether to display it as full screen or 4: 3 when the
aspect ratio of the input signal is 4: 3.
nSETTING
VOLUME
Adjust the volume from headphone terminal.
OSD TIMER
Adjust the display time of OSD.
RGB INPUT RANGE (HDMI)
Use AUTO normally. The RGB input signal range is detected
automatically.
If the RGB input signal range cannot be set appropriately
even when using AUTO, set according to the image. When
the setting is different, images will be displayed with washed
out blacks and compressed gradients.
DCR
Sets whether to use the Dynamic Contrast Ratio adjustment
function.
OVER-DRIVE
Sets whether to use overdrive.
When set to on, it reduces the feeling of residual image of
fast moving scenes.
Depending on the movie, it may not display correctly. In that
case, please set it off.
LANGUAGE
Sets the display language of the screen.
RESET
Restore main menu setting to factory default setting.
However, the setting of INPUT and LANGUAGE does not
change.
nINFORMATION
Displays the current input signal resolution and selection.
TIPS
• When WHITE BALANCE is set to LOW BLUE LIGHT,
BRIGHT and CONTRAST cannot be set.
• When DCR is set to ON, BRIGHT and CONTRAST cannot
be set.
Display Settings
11
E