Tanita 1479J Notice D'utilisation page 6

(2) Press MODE to increase the length and press TARE/CAL button to decrease.
(3) Press ON/OFF button to set.
• Battery Replacement
When batteries are running out, "Lo" is displayed and the power is
automatically turned off.
Immediately replace with new batteries (all 2 batteries). Do not apply excessive
force to the measuring section when replacing batteries.
Notice:
These marks can be found on contaminant-containing Batteries:
Pb = Battery contains lead,
Cd = Battery contains cadmium,
Hg = Battery contains mercury.
Not allowed to mix batteries with consumer waste!
As a consumer you are legally bound to return used or discharged batteries.
You can deposit your old batteries at public collection points in your town,
or wherever the corresponding batteries are sold and specifi cally marked
collecting boxes have been set up. In case of scrapping the apparatus, the
batteries should be removed from it and deposited at collection points as well.
• Backlight (1479J2)
The backlight will be turned off automatically after 5 seconds of inactivity.
• Calibration
(1) Before calibrating you must have one 200g certifi ed weight.
(2) Tum on the scale and press the TARE/CAL button for 3 seconds.
(3) The display shows "CALIb" and then will fl ash "200g".
Place the weight on the weighing tray. The scale will calibrate automatically.
(4) The following messages will appear one after another;
CALIb ⇒ End ⇒ 200.00g
(5) Calibration is complete.
Calibration is not complete when showing "Err2". Make sure the weight is
not over 200g.
- 6 -