Tanita 1479J Notice D'utilisation page 5

Instructions For Use
• Weighing
Before measuring, we recommend you to carry out a calibration (⇒ See
Calibration.)
(1) Press the ON/OFF button.
(2) The display will fl ash, and when the display shows "0.00", "0.000" or "0.0"
and Stable mark ( ), the scale is ready for use.
(3) Place the object to be weighed on the tray.
(4) The object's weight will be displayed.
("EEEEE": Over load. The object being weighed exceeds the maximum
weight.)
• MODE
In order to change the units of measurement, press the MODE button.
The units will change in the following order:
g ⇒ oz ⇒ ozt ⇒ dwt ⇒ ct ⇒ grain
• Tare Function
(1) While the scale is on, place the container to be tared on the weighing tray.
The display will indicate the weight of the container.
(2) Press the TARE/CAL and the display will indicate"0.00", "0.000" or "0.0".
(3) When an object to be weighed is placed in the container, only the weight of
the object will be displayed.
• Auto Power Off
If weighing has been completed and the weigh on the scale has not changed
for 2 minutes, the scale will automatically switch off, to save battery life.
The Auto-Power-Off time can be programmed at 0, 2, 5, 10, 20, 30 and
60 minutes according to preference.
(1) Press TARE/CAL button and ON/OFF button simultaneously when the
unit is turned off. The unit will then show the current setting.
- 5 -