Publicité
Les langues disponibles
Les langues disponibles
8. CARE & CLEANING
Clean your air conditioner regularly to
keep it looking new.
8.1 Air filter cleaning
Be sure to unplug the unit before cleaning
to prevent shock or fire hazards.
Enter the context of your task here
(optional).
1. Grasp the filters tab and pull off the
4 filters on the back of the unit one
by one.
2. Wash the filter using liquid dishwashing
detergent and warm water. Rinse filter
thoroughly. Gently shake excess water
from the filter. Or, instead of washing
you may vacuum the filter clean.
Be sure filter is thoroughly dry
before replacing.
3. Put back the filter after the filter is dry.
8.2 Cabinet Cleaning
Be sure to unplug the air conditioner
to prevent shock or fire hazard.
9. TROUBLE SHOOTING
Before calling for service, review this list.
It may save you time and expense. This
list includes common occurrences that are
not the result of defective workmanship
or materials in this appliance.
Air conditioner will not operate.
• Wall plug disconnected. Push plug
firmly into wall outlet.
• House fuse blown or circuit breaker
tripped. Replace fuse with time delay
type or reset circuit breaker.
• Control is OFF. Turn Control ON and
set to desired setting.
• P1 appears in the display window.
Drain water as described in 7.3
Drainage Section.
• Room Temperature lower than the set
temperature (Cool Mode). Reset the
temperature.
The cabinet and front may be dusted with
an oil-free cloth or washed with a cloth
dampened in a solution of warm water
and mild liquid dishwashing detergent.
Rinse thoroughly and wipe dry.
Caution when cleaning the unit.
• Never use harsh cleaners, wax
or polish on the cabinet front.
• Be sure to wring excess water from
the cloth before wiping around the
controls. Excess water in or around
the controls may cause damage
to the air conditioner.
8.3 Winter Storage
If you plan to store the appliance during
the winter, cover it with plastic or return
it to its carton box.
Air from unit does not feel cold
enough.
• Room temperature below 16°C.
Cooling may not occur until room
temperature rises above 16°C.
• Reset to a lower temperature.
• Compressor shut-off by changing
modes. Wait approximately 3 minutes
and listen for compressor to restart
when set in the COOL mode.
Air conditioner cooling, but room is
too warm - NO ice forming on cooling
coil behind decorative front.
• Outdoor temperature below 16°C.
To defrost the coil, set Fan mode.
• Air filter may be dirty. Clean filter.
Refer to 8. Care and Cleaning section.
To defrost, set to Fan mode.
• Temperature is set too low for nighttime
cooling. To defrost the coil, set to Fan
ENGLISH
17
Publicité
