Publicité
Les langues disponibles
Les langues disponibles
1.
Introduction
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of the device after its lifecycle
could harm the environment. Do not dispose of the unit (or batteries) as unsorted municipal
waste; it should be taken to a specialized company for recycling. This device should be
returned to your distributor or to a local recycling service. Respect the local environmental
rules.
If in doubt, contact your local waste disposal authorities.
Thank you for choosing Velleman! Please read the manual thoroughly before bringing this device into
service. If the device was damaged in transit, don't install or use it and contact your dealer.
2.
General Guidelines
Refer to the Velleman® Service and Quality Warranty on the last pages of this manual.
3.
General Description
Product overview
1 Screen
2 Microphone
3 Network Interface including power supply via Power Over Ethernet (POE)
4 RS-485 (Reserved) & Alarm Output Terminal
5 Alarm Input Terminal
6 TF Card Slot
7 Debugging Port
8 Loudspeaker
9 Power Supply Terminal (only use if no POE connection is available)
4.
Operation
4.1
Mounting
The wall mounting plate and junction box are required to install the indoor station onto the wall. There
are two sizes of junction boxes adapted to the device.
Size 1: 75 mm (width) × 75 mm (length) × 50 mm (depth).
Size 2: 55 mm (width) × 101 mm (length) × 38.5 mm (depth).
The dimension of mounting plate is 97 mm (width) × 104 mm (length) × 3 mm (depth).
See schematic page 2
Before you start
1.
Make sure the device in the package is in good condition and all the assembly parts are included.
2.
The indoor station supports Power Over Ethernet (PoE) (recommended) or 12 VDC power supply.
Please make sure your power supply matches your indoor station.
3.
Make sure all related equipment are power-off during the installation.
4.
Check the product specification for the installation environment.
4.2
Configuration
Startup the device:
Connect the network cable to a POE switch or injector and in turn connect it to the Internet router.
After a few minutes, the indoor touchscreen station will be automatically connected to the Internet.
1. Create a password and confirm it. Tap OK.
V. 01 – 08/03/2024
EDS150
USER MANUAL
3
©Velleman nv
Publicité
