Télécharger Imprimer la page

tomado TFS4003W Mode D'emploi page 14

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 24
Before using the fan for the first time, please proceed as follows: carefully unpack the appliance and all components
and remove all packaging material and any promotional stickers.
Keep the packaging (plastic bags and cardboard) out of reach of children.
After unpacking the appliance, carefully check it for external damage that may have occurred during transport.
Assemble the fan in accordance with the instructions.
1. Start by placing the cross foot at the pedestal. Click the pedestal in the round base of the cross foot - fig. 1.
2. Slide the four cross parts firmly in the round base - fig. 2.
3. When you attach the cross parts correctly, you will hear a click for each part - fig. 3.
4. Loosen the pedestal adjusting nut and pull the tube upwards to the required height. Fasten the pedestal adjustment nut
when the tube is at the required height. Note: if you are unable to see the tube, it is possible that it has fully disappeared
in the pedestal. Loosen the pedestal adjusting nut and carefully hold the pedestal upside down - fig. 4 and 5.
5. In order to attach the motor part to the pedestal, you must first loosen the wing nut at the bottom of the motor part.
Slide the motor part on the tube in line with the groove of the tube and tighten the wing nut - fig. 6.
Fig. 1
Sight opening
Pedestal
adjusting
nut
Pedestal
Base of cross foot
Fig. 4
Fixed
ASSEMBLY
Fig. 2
Cross part
Base of
cross foot
Fig. 5
Loose
EN - 14
Fig. 3
Fig. 6
Screw hole
Wing nut
Assembly hole

Publicité

loading